BAT_Comm-FAIL Alarm

This alarm means one of two things: 

1. There is no communication between the inverter and the battery

2. The wrong battery has been selected


Troubleshooting a potential communication issue:

  • Check the CAN or RS485 wire between the battery and the inverter. Inspect both ends and make sure that the wires spring clamp terminals have a good bite on them. Pull the wires out and ensure there is plenty of bare conductor exposed. Make sure the wires all landed in the proper terminals
  • Double check that the battery is powered on. If the battery is off, there won't be any communication between the two devices.
  • Be sure that the communication wire is not in the same conduit as the high voltage DC lines - noise will cause issues 


Verifying that the right battery has been selected:

  • While at the main screen, press Enter and then Up once to highlight Advanced Settings
  • Press Enter and then Down until "Battery Control" has been highlighted, then press Enter
  • With "Battery Select" highlighted press Enter
  • The first battery that is shown is what the inverter has currently selected
  • Lg_HV is the LG RESU10 battery pack
  • B-BOX HV is the BYD B-Box HV battery pack [note: this battery must be commissioned FIRST]
  • With the correct battery selected, press Enter and then Enter two more times to save the Force Charge and Over Discharge rates


Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.